Hand polishing AIDS represent a significant workload. Most ergonomically shaped plastic parts with Velcro are at the bottom. Removable pads can be fastened to this hook. These pads and sponges are about 3 pea-sized Klekse Polish given and spread over an area of 40 x 40 cm and only a thin oily film until worked through by the Polish is left. This polishing should be 3-4 kg “pressure” and on this area around take 5 min.
The movement type, circular overlapping movements or in the cloister (from left to right and from right to left in overlapping orbits, then the same from top to bottom and from bottom to top in overlapping orbits) is less important and thus a matter of taste. The main thing is that occurs evenly and as long as, is worked through until the finish. The remains are wiped off a soft Microfiber cloth without previous drying me. The result should be checked with a strong light source, such as floodlight, LED flashlight, or Sun. Then can proceed with the next section. Products and accessories: hand polishing, if necessary in several degrees of grinding polishing sponges/hand polishing help Micro-Fiber Cloths tape step 5: pre cleaner at hand processing to softer sponge to use a medium-firm and is 2-3 drops / Klekse on it.
This amount is a polished with slight pressure on an area of maximum 50x50cm 1 minute. The remains are to dry without prior wiped with a micro-fiber cloth. Products and accessories: Pre 1-2 medium 2-3 microfibre cloths step 6: is cleaner preservation until soft polishing sponges for the preservation of the polishing result and to protect of the paintwork against environmental influences a wax or a sealer applied. The terms are already excellently described in the FAQ. Also here the personal preference decide because you can not more generally tell which category of the product lasts longer, is easier to handle, or better shines. These finishing products be applied generally by hand. Soft or liquid products can be applied but also the machine with a soft pad. The seal is very similar to the growth. However, the consistency of the products is liquid until very soft-paste like. This can be an easier the seals on the Auftragspad, on the other hand it is quickly take too much. Again, more is less. Whether the product in straight lines or circular motion is applied is beside the point, an opaque, thin order is important. After a product specific drying time, taking the residue with a soft Microfiber cloth. You can determine the exact time to dry with the finger test, by one rubbing with a clean finger over the sealed surface. A smear-free track is back, the sealer is ready for the take off. Products: Seal 1-2 Auftragspad 2 Micro-Fiber Cloths recommended products for car care Diamondbrite car care…