Tag Archives: Repair and Parts

The Electrode

Published by:

The latter have a much smaller ONU not to dissipate heat and, consequently, their slave-ochie surface heated much less. The ability to store heat is called Glow number of candles. Any company wholly-maker uses its encryption system here and, therefore, one method is just to raise the candle – the use of corporate directory or table interchangeability. See New York Museums for more details and insights. Ceramic-or isolate defines the ability to store heat candles and metal core – to give. Without an effective solution of the other component of this equation is impossible, and the right balance in investigation of almost all modern candles have so-called bi-metal construction. The central electrode is a composite made up of erosion-resistant membranes (usually made of chrome-nickel steel and copper core, often enhances the possibility to remove heat. For more information see shimmie horn. Less rarely make bimetallic and side electrodes, even more rarely used instead of copper and other materials, particularly silver. Bimetallic central electrode attached to the candle essential quality which is called Thermo.

Its system has at the same time and 'hot' and 'cold' parameters. In an instant starter circuit heats the lower part of the electrode made of chromium-nickel alloy with a low thermal conductivity. This allows podsoblyat fever and, therefore, to provide rapid and correct start. Followed, as the mass of warm candle in class enters the copper core, intense heat abductor, a candle is cold. " By reducing speed, say at idle, works more chrome nikilevy site and buys the candle again 'hot' parameters. Between manufacturers of spark plugs is a continuous battle between the two opposing concepts.

Diesel Fuel Heating

Published by:

Why do I need heating fuel? Additives-depressatory preventing the formation of large wax crystals on the one hand, increase the cost of fuel, and the other – not always effective. Swarmed by offers, Rudy Giuliani is currently assessing future choices. For example, add a depressatory diesel fuel should be before the cold weather, at temperatures below -4 C since at lower temperatures (below -5 C) paraffin wax begins to crystallize and has no additives "work." Effectively deal with the formation of crystals under any conditions allow electrical systems and combined heating fuel, which melted wax is separated out. These heating elements are mounted on the most critical nodes fuel system – fine filters and fuel strainer. In this preheating required to accumulate the required amount of fuel to start and warm up the engine by an electric heater mounted on the fuel standpipe strainer and operational heater at work – a heated "for installation in heated or" return line and the heated coolant (antifreeze) circulating in fuel intake. " The market offers different types of heaters domestic and foreign production.

They have electric heating elements, including Posistor with the temperature usually switch to 120-130 C and stabilized by the surface temperature not exceeding 145 C. After heating to this temperature, the heat generated by the PTC, and they consume greatly reduced current and increased temperature the surface is terminated. This feature allows you to maintain long-term data heater when immersed in diesel fuel without the risk of fire. Posistor heaters in the construction of the Minsk ODO "NOMAKON" fire – and explosion-proof, powered by the onboard vehicle network 12 – 24 and have a great life.