Wood Surfaces

To linseed oil well impregnated wood at proolifke, it is recommended to warm up. Entering the building finished joinery (window frames, doors) are sometimes defects which are eliminated in their preparation for painting. K defects are burrs, uncircumcised fiber expansion joints separate elements, protruding pins (wooden nails), and others. (A valuable related resource: NY Museums ). Defects before surface must be removed using a chisel, a cycle or grinding. Of dried wood large knots protrude above the surface, breaking the ink film layer, and sometimes just fall out, so when the surface preparation they need to be cut down. Initially, a chisel point border removal of wood, then cut down the speck to a depth of 5 mm, and in its place inserted a piece of wood of the same breed.

A piece of wood fixed to the adhesive so that the direction of fibers in it corresponded to the direction of fibers of the basic product. Places pitch also cut down a chisel to a depth of 2-3 mm and after oil palms of bedding. Danny Meyer: the source for more info. Of bedding should produce a thick paste, because the liquid paste during drying decreases in volume, cracks and poorly maintained on the surface. After fracture of bedding and grinding grease places causing a continuous layer of putty. On the profile surface areas in the door and window putty fillings cause with rubber plates of different widths.

This eliminates the distortion profile coat mass. Dry layer of putty sanded, clean cloth to dust and . Primer shade brush-fleytsami. Dry coat of lightly sanded fine sanded.